FZ6/FZ6R Kill Switch Assembly?
Posted: Fri May 24, 2019 5:33 pm
Has anyone successfully used the start/stop/kill switch (right hand handlebar switch assembly) from an FZ6/FZ6R? I'm looking to replace my very weathered switches with something newer from the Yamaha lineup. However, our Seca II's use a throtle cable setup that does not go through the right-hand switch assembly, and the FZ6/FZ6R does.
The FZ6/FZ6R does use throttle cables with our familiar 90-degree bend, though, and they even appear to have similar square "nubs" like ours.
This is what I'm considering. Since it isn't in my hands, I cannot simply try it out without ordering/shipping/etc. So I'm turing to the collective group experince...
Thank you in advance
The FZ6/FZ6R does use throttle cables with our familiar 90-degree bend, though, and they even appear to have similar square "nubs" like ours.
This is what I'm considering. Since it isn't in my hands, I cannot simply try it out without ordering/shipping/etc. So I'm turing to the collective group experince...
Thank you in advance