Transmission install - circlips, only one?
Posted: Sun Feb 07, 2016 4:29 pm
Finally got my starter gears swapped out, getting ready to put the engine back onto the trans, have a question... Are the transmission bearing circlips only one sided, reffering to page 138 of the factory 1992 repair manual.
I only have 4 total, the book says they go on the top so Im assuming you dont have a set that go in the bottom slots as well but wanted to ask!
I only have 4 total, the book says they go on the top so Im assuming you dont have a set that go in the bottom slots as well but wanted to ask!