Page 1 of 1

Carb Tuning with a Wideband O2 sensor

Posted: Wed Apr 11, 2012 7:17 pm
by radare
I purchased an AEM UEGO gauge and Bosch sensor on EBay for $160. The AEM kit included the gauge, wideband sensor and wiring harness. Essentially everything needed to tune an XJ:
Image

Image


The wiring and sensor are very nicely done and all I had to do was solder on some terminals so I could hook it to the battery.
Image


Here's the starting point for number 1. Rich.
Image


And the finish point for number 1. Better.
Image


So while trying to tune with the sensor, I was getting some odd swings on the #1 and #4 cylinders and the #3 has the pilot jet only about an 1/8 turn out. This tells me I need to go through the carbs before trying this again. I have plans to pull the carbs this weekend and give them a good old-fashioned and thorough soaking. I think two winters of not draining the fuel has taken it's toll on them.


Here's a short video of my attempts to understand and tune (filmed with my new Sony Cybershot camera). It follows cylinders 1 and 2's tuning (or attempt). Cylinders 3 and 4 were likewise, with similar results. We'll try again after a thorough cleaning. Stay tuned.

[youtube]dKArqdgih9U[/youtube]